一起先导式安全阀未超压起跳故障分析

通过对一起先导式安全阀起跳的原因进行分析,认为该安全阀起跳的主要原因是工艺操作未控制好及未按规范要求落实定期校验制度,并就先导式安全阀的使用、维修、校验等环节提出应对措施。     

热解条件对废电路板真空热解规律的影响

采用自行设计的间歇式固定床真空热解中试装置对废线路板进行了真空热解试验;研究了物料尺寸、热解终温、升温速率、真空度及恒温时间等热解条件对热解产物产率分布的影响和废线路板真空清洁热解过程的规律.试验结果表明,热解条件决定废线路板的真空热廨规律,热解终温是影响热解产物产率分布的最重要的热解条件,其它热解条件对热解产物产率分布也有一定影响.在物料尺寸为50 mm×50 mm、热解终温为550℃、加热速率为10℃·min-1、热解压力为20 kPa及恒温时间为60 min的热解条件下,有利于降低热解固体产物产率,同时有利于提高热解液体产物产率和减少处理费用.     

农业面源污染防治研究现状与展望

农业面源污染是影响水环境质量的重要污染源,对水环境的污染贡献率逐年提高,逐渐成为制约农业可持续发展和实现农村现代化的环境瓶颈。文章在广泛调研国内外相关领域研究成果的基础上,综述了农业面源污染防治相关领域的研究进展,主要包括:农业面源污染物流失特性研究、土地利用方式影响研究、农业面源污染控制和治理技术研究、面源污染模型研究、现代电子信息技术的应用以及最佳管理措施(BMPs)的研究与实践等。最后,对农业面源污染控制领域未来重点研究方向进行了展望,并提出了相关建议。     

移动监测法测量厦门春秋季近地面CO2的时空分布

移动监测对研究城市近地面空气污染物时空分布特征具有重要意义.本研究采用野外移动监测车,利用二氧化碳测量仪、粉尘仪及小型气象站,在春秋季共选取14 d,沿厦门不同功能区,在每天不同时间段(09:00~12:00、13:00~16:00、22:00~01:00)进行了CO2与颗粒物(PM)浓度及气象参数的监测,并分析了春秋季不同时段下各功能区近地面CO2空间分布特征以及CO2与颗粒物的相互关系.结果表明:①监测期间,路线从北部的坂头水库背景区经郊区进入市中心最终在城市南部边缘沿海干道结束,CO2浓度的空间分布呈现中间市中心高沿市中心向两边边缘处降低的结构,不同功能区CO2空间分布存在差异,受城市交通,工业,人类活动等排放,地面植物/作物以及气象条件的影响.主要表现为交通繁忙区(仙岳路/厦禾路/嘉禾路,477.33μmol·mol-1±6.11μmol·mol-1)高于商业居民区(杏林/思北,454.95μmol·mol-1±5.45μmol·mol-1)高于自然风景区(文屏/环岛路/演武路,441.01μmol·mol-1±6.24μmol·mol-1)高于耕地(农田,436.79μmol·mol-1±1.87μmol·mol-1)高于山体林地(坂头水库,434.06μmol·mol-1±0.31μmol·mol-1);②监测期间春季平均CO2浓度为452.04μmol·mol-1±20.24μmol·mol-1,最大值出现在2013年4月12日的嘉禾路路段(市内交通繁忙区)为533.10μmol·mol-1,最小值出现在2013年4月10日的坂头水库路段(远离市区,受人为活动影响较小,水库周围有大量植被,可认为监测过程中的背景区域)为413.25μmol·mol-1.秋季平均CO2浓度为451.80μmol·mol-1±21.56μmol·mol-1,其中最大值出现在2012年11月19日的厦禾路路段(市内交通繁忙区)为526.45μmol·mol-1,最小值出现在2012年11月20日的坂头水库路段为415.01μmol·mol-1.这符合Idso等在1998年提出"城市CO2岛"的现象;③不同时间段CO2浓度表现出夜晚时段(22:00~01:00)高于上午时段(09:00~12:00)高于下午时段(13:00~16:00),阴天普遍高于晴天,且不同功能区CO2浓度在夜晚时段(22:00~01:00)和白天时段(09:00~12:00和13:00~16:00)的差异不同,春季的差异范围为-0.66~29.48μmol·mol-1,秋季的差异范围为-4.01~33.69μmol·mol-1;④市区CO2浓度与周围郊区存在差异,市区CO2浓度均高于郊区;⑤移动监测主要受道路车辆排放的影响,CO2浓度与PM2.5呈显著正相关关系(R=0.73,P<0.01).     

中试规模微气泡曝气生物膜反应器运行性能评估

运行中试规模微气泡曝气生物膜反应器处理校园生活污水,对其运行性能进行评估,并与传统生物处理工艺比较.结果表明,采用中试系统处理校园生活污水原水时,平均COD去除率和去除负荷分别为57.0%和2.68 kg·(m~3·d)~(-1),平均氨氮去除率和去除负荷分别为17.4%和0.17 kg·(m~3·d)~(-1),平均TN去除率和去除负荷分别为15.8%和0.21 kg·(m~3·d)~(-1),平均氧利用率达到100%.采用中试系统处理可生化性较差的生物接触氧化池出水,平均COD去除率和去除负荷分别为46.0%和1.53 kg·(m~3·d)~(-1);平均氨氮去除率和去除负荷分别为17.1%和0.32 kg·(m~3·d)~(-1);平均TN去除率和去除负荷分别为14.1%和0.28 kg·(m~3·d)~(-1);平均氧利用率高于50%.由于微气泡曝气能够加速氧传质过程并提高氧利用率,因此相同进水条件下,中试系统污染物去除能力显著优于传统生物接触氧化工艺和传统曝气生物滤池工艺.     

船舶引航员可靠性评价体系研究

为有效预测船舶引航员作业中的安全可靠性,预防引航事故,基于其职业特点,提出了情绪状态、注意力、心情状态等动态和静态评价指标各5个,并采用专家评价或自评的方式对指标赋值。采用专家调查、DEMATEL方法,研究、验证了指标的合适性和指标间关系的正确性,并确定了各指标的权重。结果表明:引航员心情状态的权重最大(0.123 6),基本生理素质的权重最小(0.082 6);最后通过案例分析,得到某一级引航员的可靠性值为91.342 5。引航员在工作中有良好的心理和生理状态以及良好的操作技能,有助于引航员可靠性的提高,从而减少引航事故的发生。     

Workspace design for crane cabins applying a combined traditional approach and the Taguchi method for design of experiments

Procedures in the development process of crane cabins are arbitrary and subjective. Since approximately 42% of incidents in the construction industry are linked to them, there is a need to collect fresh anthropometric data and provide additional recommendations for design. In this paper, dimensioning of the crane cabin interior space was carried out using a sample of 64 crane operators’ anthropometric measurements, in the Republic of Serbia, by measuring workspace with 10 parameters using nine measured anthropometric data from each crane operator. This paper applies experiments run via full factorial designs using a combined traditional and Taguchi approach. The experiments indicated which design parameters are influenced by which anthropometric measurements and to what degree. The results are expected to be of use for crane cabin designers and should assist them to design a cabin that may lead to less strenuous sitting postures and fatigue for operators, thus improving safety and accident prevention.     

NitroMAC: An instrument for the measurement of HONO and intercomparison with a long-path absorption photometer

NitroMAC (French acronym for continuous atmospheric measurements of nitrogenous compounds) is an instrument which has been developed for the semi-continuous measurement of atmospheric nitrous acid (HONO). This instrument relies on wet chemical sampling and detection using high performance liquid chromatography (HPLC)-visible absorption at 540 nm. Sampling proceeds by dissolution of gaseous HONO in a phosphate buffer solution followed by derivatization with sulfanilamide/N-(1-naphthyl)-ethylenediamine. The performance of this instrument was found to be as follows: a detection limit of around 3 ppt with measurement uncertainty of 10% over an analysis time of 10 min. Intercomparison was made between the instrument and a long-path absorption photometer (LOPAP) during two experiments in different environments. First, air was sampled in a smog chamber with concentrations up to 18 ppb of nitrous acid. NitroMAC and LOPAP measurements showed very good agreement. Then, in a second experiment, ambient air with HONO concentrations below 250 ppt was sampled. While NitroMAC showed its capability of measuring HONO in moderate and highly polluted environments, the intercomparison results in ambient air highlighted that corrections must be made for minor interferences when low concentrations are measured.     

Measurements of indoor radon concentrations in the Santiago de Compostela area

Galician soils are among those with the highest (222)Rn exhalation rates in Spain. A year-round study of the indoor (222)Rn concentration in buildings in the Santiago de Compostela area (Galicia, Northwest of Spain) was performed. The study is based on systematic samplings with active charcoal canisters, following a modified EPA 520/5-87-005 protocol. These measurements were complemented by others obtained using etched track dosimeters. Each data set follows a log-normal distribution, with a geometric mean of (253+/-3)Bqm(-3) for charcoal canisters and (285+/-2.5)Bqm(-3) for etched track detectors. After correcting for the different measuring conditions, the mean value of both methods differed by only 2%. A careful analysis of the seasonal dependence of our measurements did not reveal any significant seasonal variations in the (222)Rn concentration. Parallel to these measurements, different meteorological parameters were recorded, which revealed a direct correlation between the indoor radon concentration and the outdoor temperature derivative with respect to time.     

Comparisons of Measured and Modelled Ozone Deposition to Forests in Northern Europe

The performance of a new dry deposition module, developedfor the European-scale mapping and modelling of ozone flux to vegetation, was tested against micrometeorological ozone and water vapour flux measurements. The measurement data are for twoconiferous (Scots pine in Finland, Norway spruce in Denmark) and one deciduous forest (mountain birch in Finland). On average, themodel performs well for the Scots pine forest, if local inputdata are used. The daytime deposition rates are somewhat over-predicted at the Danish site, especially in the afternoon. The mountain birch data indicate that the generic parameterisationof stomatal responses is not very representative of this northernspecies. The module was also tested by using modelled meteorological data that constitute the input for a photochemical transport model.